DH 9116 Doesn't work, slow blinking red light on copter
Just unboxed my DH 9116....charged....good batteries in remote.
I turn on the remote, let it go though it's checks, then turn on the helicopter. I get the initial servo "jump", but the red light on the helicopter flashes very rapidly for about 5 seconds and then settles into a slow red blink.
No control inputs on the remote work at this point...not sure what to check.
The same thing happened on my 9053 when I took it out of the box. I contacted XHeli where I bought it. They sent me out a new control board at no charge and now it works fine.
|All times are GMT -5. The time now is 11:32 PM.|