RC Groups

RC Groups
    Eagle Tree Systems
        Discussion Please post photos of your sensor installations here!

#1 billpa Jul 16, 2010 10:50 PM

Please post photos of your sensor installations here!
 
Here's a small collection of sensor installations, for starters.

http://www.eagletreesystems.com/Support/photos.htm

Please post others here!

#2 garris2 Jul 17, 2010 08:32 AM

11 Attachment(s)
This is some pics of Eagletree's baro airspeed and altitude sensors embedded in the wing of my Cularis glider. I'm using them with my FPV setup.
I carved a groove on the bottom side of the wing over the servo wire channel, this allowed me to run the daisy chain wire to the root of the wing where an additional connector mates up when I plug the wings into the fuselage. I have a piece of lexan covering them. Its sunk into the wing flush with the surface. There is nothing protruding except the pitot tube.

Geoff

#3 dicharry Jul 17, 2010 11:01 AM

Thanks Billpa for this sticky. There are some great ideas here and I'm sure the list will grow. A picture IS worth a thousand words.

#4 Rem 1973 Jul 27, 2010 09:56 AM

2 Attachment(s)
Here are two photo's of my installed Optical RPM sensor, and Temp sensor.
Installed on a RCMK 2 stroke gas motor.

Greetings,
Remco.

#5 nick_cool Sep 19, 2010 08:02 AM

RPM sensor
 
2 Attachment(s)
Here they are my brushless sensors installed.

The first has two needles soldered.

For the second I made two male-female adapters (3mm bullet)

Good landings

#6 pda75 Sep 20, 2010 10:33 AM

2 Attachment(s)
here is mine

Before and after....

Cheers

Pierre

#7 Terry Keeley Sep 27, 2010 12:02 PM

Rpm sensor.
 
Attached the sensor with heat shrink, bored the hole in flywheel with 0.0005" press fit. Works great!

http://gallery.intlwaters.com/albums...logger_001.jpg

#8 ValBoo Apr 06, 2011 12:23 PM

Hi Terry,
Nice install... thanks for the good pic.

#9 Eddy de Vries Jul 09, 2011 05:21 AM

4 Attachment(s)
Here are some pics of how I mounted the magnetic RPM sensor in my Zenoah 2 stroke outboard. I secured the sensor with heat shrink afterwards.

Rgds, Eddy


All times are GMT -5. The time now is 10:59 PM.