RC Groups

RC Groups
    Radios
        Discussion Airtronics RF radio module question on pins.

#1 TexasThermalKing Apr 02, 2010 01:46 AM

Airtronics RF radio module question on pins.
 
Does anyone have the schematic of what each pin, located on the 72 mhz Airtronics plugin modules is linked to? I have a Vision 8SP radio I was looking to convert to 2.4 ghz. It uses the TX RF Module #93782.
If you have suggestions on a good way to convert it, please let me know.
If you are using a particular 2.4 system...let me know what you like about it.
Thanks !

#2 Tim Wolff Apr 02, 2010 09:22 AM

I've only done some limited research, but the generic 2.4 modules that I've found connect to the trainer port. If the Vision has one, it should be fairly easy to determine the pinout.

#3 TexasThermalKing Apr 02, 2010 10:30 PM

No tranier port on the Vision 8SP.
 
Tim, Thanks for your response...but the Vision 8SP has no trainer port. I'm
I'm trying to figure out the pins functions...so I can use a 2.4 ghz board, or hack module to see if I can get up on 2.4ghz.
Anyone that has information on the Airtronics 72mhz plug in modules, would be appreciated.

#4 TexasThermalKing Apr 30, 2010 04:27 PM

Update...found pin locations for Vision 8SP radio.
 
Working with the FrSKY 2.4 hack module, that I used to convert my Airtronics Vision 8SP radio....I found the positive, negitive, and PPM pin locations I needed on the XPS website. Thanks XPS, I appreciate your detailed help!


All times are GMT -5. The time now is 06:22 AM.