RC Groups

RC Groups
    Electric Warbirds
        Help! PBY Catalina (Guanli) Brushless Suggestions

#1 dmoench Jun 13, 2009 09:55 AM

PBY Catalina (Guanli) Brushless Suggestions
 
Hello,

I've purchased the arf version of the Guanli Catalina and plan on putting in some brushless motors along with a tri blade prop.

I will be flying off a mountain lake around 8000 ft. elevation so I don't mind a setup that may be slightly overpowered.

Please let me know your suggestions for powering this plane.

Thanks.

#2 reacher10 Jun 13, 2009 10:42 PM

Maybe ask over in the Power System forum. I think there would be a wealth of knowledge over there.

I have the same plane...crashed it good 2X but fixed it pretty easy. I'm at sea level and I'm going to put 2 of these in it running on a 11.1v 2200 mah lipo.

http://www.rchotdeals.com/Products/r.../2208_18a.html

I think it will fly great.

Good luck!

#3 pops57 Jun 17, 2009 08:54 PM

Hi, I have this same bird and i have up graded to brushless. I used 2 FC28-22 1200 kv motors from Hobby City, the specks they give are 14.5 amp max on a 10 inch prop and 3s lipo suppling around 700 grams thrust. I am very happy with my power level now, I can place the Cat on the ground-no wheels and it will power off the ground no problem. I use a set of 9 inch three blade props with a 7 pitch. I am not anywhere near your altitude so I can't say how much power loss you might see. I have not pushed this bird to see what it is cappable of as it just looks so cool flying in scale fashion. I have made several flights from water as well and have come to the conclusion I need to fabricate a water rudder. Hope some of this is helpful. Good Luck.

#4 jzonts Jun 17, 2009 09:30 PM

I upgraded with bp hobbies motors, here is a link to the thread with video http://www.rcgroups.com/forums/showt...8#post12381113
In the video i was at around 9000 ft. elev. and had no problem what so ever with power.

#5 dmoench Jun 19, 2009 12:25 AM

Very helpful. It looks like your setup works well at high elevations. I would like to have a tri blade prop for a closer to scale appearance.

I have heard the the Turingy motors may be a good fit. I'm looking at the 2209 from United Hobbies.
http://www.hobbycity.com/hobbycity/s...idProduct=5686

If you have any info on these motors and supplier, I would appreciate it.


All times are GMT -5. The time now is 08:25 PM.