HorizonHobby.com Shop our Airplanes Products Shop our Surface Products
3DMON's blog View Details
Posted by 3DMON | May 11, 2013 @ 11:12 PM | 5,614 Views
I've done a little mod to make it so my servo wires are not held in permanently.
Basically carve the foam out wider where the servo wire guides are already at but on the fuse it needs to be a little bigger so the connector can clear the bend area (see pic). This also makes it so I do not need an extra servo wire extension in the wing extension because the servo's wire is long enough to go all the way through it and then with out the wing extension I can push the extra wire in the groove I made in the wing before sliding it on.