Posted by CyberJay |
Feb 16, 2010 @ 10:31 PM | 10,005 Views
Round two with 3DHS. I had the 40" Edge about a year ago and I liked it. I was progressing well until I rammed it into the ground.. I'm definitely NOT a 3D guy but I do enjoy the challenge.
I tried to keep it as light as I could. Only one extension and it's 32awg. I soldered the motor's wires directly to the ESC. No shrink wrap on the ESC. Minimal hardware, all bolts and pushrods cut as short as possible, used as few washers as possible, etc. The motor and battery are heavy, everything else should be as light as possible.
*** SOLD 09/13 ***
AUW: 34oz w/ the 188g 2200mah pack and wheel pants ON
Static test: 340 watts