Posted by 1sq | Feb 21, 2014 @ 04:33 PM | 2,389 Views
ImagesView all Images in thread
Crooked copper strip, 18 gauge wires for ESCs, two power tap, Scratch paper, as per CC3D motor layout for a hex, I will placed each escs like this to keep motor wires length to a minimum.
Applied liquid tape after cleaning off flux. I made sure negative and positive are not shorting out.
Still need to de-solder old power/ground lead and solder new wires to length. RX smacked down on top of the CC3D. I might make the tray to be able to slide back and forth, not sure if there is noticeable benefit by doing so.