Aerosky Sbach 342 servos placed too far rear.
I recently purchased an Sbach 342 from from nitroplanes.com. I purchased the 1400 millimeter or 55 inch version. The original showed 3 micro servos in the center of the plane which control the rudder an elevator. When I receive the same plane the design had been changed and now there are 2 standard size servos in the very rear section of the plane. I have had to add 150+ grams to the nose and use a 3300mah battery just to even out cg. Plane is now not able to do 3D, which it was advertised as. Anyone else seen this.