#1 Report
steelofwar
Registered User
Joined Jan 2013
0 Posts
Trader Rating: 0
i need a blowen crank shaft from 91 size nitro engine
i need a blowen crank shaft from 91 size airplane nitro engine so i can cut off the part you put the prop on and weld it on a weed wacker engine please help

my email is olsont68@gmail.com
thanks for your time

Yesterday, 02:44 PM
#2 Report Delete Post
ae4sh
Registered User
United States, NC, Cherryville
Joined Dec 2012
4 Posts
Trader Rating: 18
Heres a bit of advice,
the cranks are hardened and will become brittle when heated or welded.
I'm a retired welder with 30+ years expertince.
Scott

Yesterday, 03:01 PM
#3 Report Delete Post
sagomon
Registered User
Joined Oct 2010
191 Posts
Trader Rating: 96
there are easier ways to make a prop adapter and I think some kits are around to fit some of them

Today, 11:13 AM
#4 Report
steelofwar
Registered User
Joined Jan 2013
0 Posts
Trader Rating: 0
what should i do then i need the bell cluch and i need to use the pull start for the weed wacker and i need some way to ether weld a on a drive shaft. or do you know a way icould get the same bell cluch made with a dirve shaft with a t