SMALL - espritmodel.com SMALL - Telemetry SMALL - Radio
builder8319's blog
Posted by builder8319 | Jan 01, 2013 @ 04:47 PM | 1,711 Views
Hi,

I am in need of a Fuselage jig for most kit builds and a wing jig that will work most kit builds does anyone know of any that are good and that will work with a wide range of kits? I know bob homan of bob holman plans and just wanted to ask you before i buy.
Posted by builder8319 | Dec 31, 2012 @ 05:48 PM | 1,753 Views
Hello, I am Chris Campbell with rcairplanebuilders.com and I have a OS .61 nitro engine for a mid size piper cub that I am doing a engine rebuild on. well i am trying to remove the drive washer I have had a easy time in the past with my drive washer puller from hobbie partz, well To make a long story short I am going to replace the rear and front bearings and clean the carb, piston, and cylinder, and re tap the glow plug hole, I am also going to clean the crankshaft, but I can't seem to get the drive washer off, I have heated it up in my shop oven at 375degrees for 10-12 mins, and even used my puller but all its doing is smashing up the drive washer, so I will replace it with a new one once I get it off. the engine was badly rusted, and was in need of a rebuild and clean. I only charge $75 to rebuild an engine and I need help if anone can tell me a best way to get it removed with out any damage to the front housing.

again thanks, fill free to call the shop (864)871-2577
Posted by builder8319 | Dec 31, 2012 @ 09:54 AM | 1,432 Views
Hello, This is Chris Campbell Of rcairplanebuilders.com I am in Laurens,sc Is there any R Plane Fly Ins in Ga Or North east FL? I know about the swap meat in Perry,GA But I would live to come to a RC Plane Fly Event in GA Or Nort east FL.

I Build and work on RC Planes and Do Engine work But I most love to fly!!:

I get in work from all over the USA Right Now I am builder a Extra 250, a giant big stick, and a Sabash 360 . but when i am off I want to fly. any info would be great!! Also if you know of anyone with a lot of rc parts for sale i use them all the time.
Posted by builder8319 | Dec 30, 2012 @ 08:23 PM | 1,958 Views
Hello. I am New here And I am Not New To RC Planes Are Flying, In fact I am a full time RC Airplane builder and engine repair person, www.rcairplanebuilders.com If Any one every needs a ARF Built, or any work done let me know! I own my own hobby shop of parts, and have built some great planes for pro to 3D sport Pilots.

If any one has any cheap ARFs for sale I may want to buy as I buy to fly myself.

Thanks Chris