Latest R/C Blog Entries
Foam Jet 758 Grams Mass 500 Grams Thrust 90 mm EDF 14.5 Volts Turnigy 20 ESC
| Nov 15, 2012 @ 03:32 AM | 1,586 Views
500 Grams of thrust 90mm EDF with Turnigy L2210-1650
Cobbled together 90 mm fan with 250 Watt Turnigy L2210-1650 Bell Style Motor (250w) seeing if I can get decent efficiency from a small fan turning slower.
Weighs around 150 grams now.
On 14.8 Volts its pushing almost 500 Grams, not so bad thrust mapping is as follows.
100 Grams 1.9 A 27.6 Watts
156 Grams 3.0 A 42.9 Watts
197 Grams 3.9 A 55.1 Watts
257 Grams 5.5 A 76.0 Watts
296 Grams 6.7 A 90.9 Watts
340 Grams 7.9 A 105.5 Watts
432 Grams 10.7 A 138.1 Watts
492 Grams 12.5 A 155.7 Watts
The data in a spread sheet
The tests were run on two 7.4V 1300mAh Turnigy 20C Lipo's in series, I figure the motor will survive full throttle bursts on 4C and its 10 Amps short of the max, 100 Watts below its spec.
Its surprising as the same motor with a 8 X 6 prop pulled 23.3 Amps on a 3C yielding 520 Grams of thrust at 232.3 Watts.
Got this battery on its way from Hobby King Rhino 1550mAh 4S 14.8v 20C Lipoly Pack
RC Boats Plane Electronics Design
Posts Per Day:
Most active forum:
Racing Boats - Electric
(74.60% of user's posts)
Most active topic:
Unofficial NQD Tear Into Jet Boat Mod Thread
(69.84% of user's posts)
Find all posts by nickatredbox
Find all threads started by nickatredbox
Find all attachments by nickatredbox
Oct 14, 2013
Jun 13, 2012
Find all articles by nickatredbox
Search This Blog
Showing Friends 1 to 2 of 2
foam and tape
Winging it Ò>
Send an Instant Message to nickatredbox Using...
Subscribe via RSS
The last 5 visitor(s) to this page were:
foam and tape
This page has had
All RCGroups content copyright © 1996 - 2014 by RCGroups.com.
The E Zone
RC Heli Resource
Terms of Service
Mark Forums Read
Back to Top