Posted by jlk69 |
Jul 10, 2012 @ 12:18 AM | 4,167 Views
Here are a couple of pictures of my mCP X Rx. While soldering the signal wire for the ESC to the motor fet I think I got the fet just to right too hot and now I can't bind Rx with Tx. After plugging in battery I do not get the slow blink of the blue light but only a fast blink. Hold the boat, got it to bind with another battery but looks like the motor was bad all along. However I will do more tests and report back my findings.
This is the cable that I got from HobbyKing that is supposed to allow me to hook up my Turnigy 9x to my PC and use the Phoenix RC Sim. Is this the correct cable because I don't see any of these plugs on my Tx except the audio patch cable. I think I got the wrong package.
I was able to transplant the part that broke on my S-107 Tx from my "fake" S-107 Tx. I included pictures of the broken part (glued back together) and the donor Tx to show you where that part came from. The donor part was plastic but the part that broke was pot metal. I had to unsolder the legs from the board and take apart that metal cage then swap out the part.