Shop our Airplanes Products Shop our Surface Products
trinco's blog View Details
Posted by trinco | Feb 25, 2016 @ 04:06 PM | 2,035 Views
To those who'd like to grab this frame please visit FPV-Reconn.com
http://fpv-reconn.com/store/index.ph...product_id=169

Since all the edges are too sharp i had to sand down the edges to make it smooth. These were all the parts that i've chosen to sand down.


A closeup picture of the sanded edges. Pain in the ass job but worth it.


Sealing the edges of the carbon fiber with CA glue which further helps to prevent the separation (de-lamination).
...Continue Reading
Posted by trinco | Nov 09, 2015 @ 10:56 PM | 2,697 Views
This will be my second RD180 build. The first built was in a rush, i had to build it 4 days before Malaysian Aerial Grand Prix race so i didn't log any of it.

For this build im going to be using Matek System Mini PDB with built in 5v & 12v step-down regulators. Main power leads has been soldered on the PDB.


I have four FVT littlebee 20a ESCs ready for this build. Also i've soldered a JST-GH (1.25mm Pitch) connector on each of these ESCs for easy firmware flashing.


The BLheli version that came with this ESC is version 14.0. With the JST-GH connector now i can connect to silabs chip and flashed to the current latest BLheli firmware which is 14.2. After the new firmware has been flashed i no longer need the JST-GH connector because i can directly flash and change BLheli directly using naze micro-usb port.
...Continue Reading
Posted by trinco | Nov 26, 2014 @ 05:05 AM | 3,309 Views
JST-SH soldered. I will be using TX/RX from naze to my minimOSD



Wiring all done



I will be using CCD cam that i bought from surveilzone with 2.5mm lens. I spayed both sides of the PCB with PLASTI DIP.
...Continue Reading