Espritmodel.com Telemetry Radio
kman76's blog
Posted by kman76 | May 28, 2013 @ 10:42 AM | 4,001 Views
Guys,

I am testing the simulation with my new APM2.5 FC , followed the diydrones wiki manual on the simulation process with FlightGear/Xplane which is not that clear. I hope somebody will chime in here and share/resolve the common issues and how to troubleshoot them..

My Test Results & Issues:

I was able to install the Mission Planner, FlightGear softwares successfully.

Issue 1: When i try to upload the HIL Plane/Quad HIL fw on to APM2.5, process seems to be Done successfully but, APM won't work properly(All LEDS wers on) and no GPS FIx.When i loaded the regular quad fw everything worked properly. I don't know if the HIL fw has any issues.

The HIL FW that i loaded was V2.9.1b i think.
Posted by kman76 | May 11, 2013 @ 10:15 AM | 3,728 Views
Yesterday i tried to upgrade my DJI Naza-M V1 controller with the new v3.10 firm ware and after TX Command Stick calibrations i followed the power cycle and when i i try to arm motors they were not arming. So i connected back to new Naza Assistant software(2.10) and noticed that TX Command Stick calibrations were not saved and lost. They are not showing in green and they were off.I dont think motors arm with out the proper calibrations. I had everything worked fine with old FW 2.10 on NAZA-M V1. I don't know what exactly the problem is. Any tips would be appreciated..Thx

Here is My Setup:
Turningy 9X Radio
ESC- RC Timer 30Amp ESC's -With Simonk FW
RC Timers 750KV motors
Posted by kman76 | Jul 08, 2012 @ 10:58 AM | 4,530 Views
Folks,

I am planning to build a quadcopter for FPV using Multicopter X650 V4 Air Frame from RcTimer.com which looks to be very nice , But unfortunately i have not came across any information about this frame in google or rcgroups or youtube. Guys pl's let me know if any body had tried earlier and would like to share their experience..Any suggestions and recommendations would be helpful.

http://rctimer.com/index.php?gOo=goo...cat=158&gtype=
http://rctimer.com/index.php?gOo=goo...5&productname=

Here is the list of things that i am planning to use for this project..
1. DJI NAZA - M Controller
2. NTM Prop DRIVE SERIES 28-30A 750KV / 140W (With 10x4.5 Props)- From HobbyKing.
3. Turnigy Plush 25 A ESC's or RCtimer 30A ESC's
4. Turnigy 9X TX & RX
Thx