HobbyKing.com New Products Flash Sale
Wolfking44's blog
Posted by Wolfking44 | Oct 23, 2012 @ 04:26 PM | 1,224 Views
HI I am wolfking44,
and I am starting my journey into RC I am going to start off this epic quest with an ornithopter and I now that lots of you that are reading this think that I am bitting off more than I can chew for my first project but hey I like a challenge!!!

step one: planing
I found some plans online and I am or should I say I was going to use them but I decided to just use them as a reference mostly because I want my ornithopter to have a larger wingspan.
so plans so far
wingspan: 25"
length: un known at this time
motor" is taken care of
servos: source found have not bought yet
receiver: do not know yet
batteries: no clue at this point
the hard ware will conceit of carbon rods for the front wings and tail wings, balsa or carbon plate for body and that is most of it
transmitter: looking for a Dx6i for under 100$ or a package deal with any heli or plane for 200$ or less
know any one, keep me in mind if you do

any ideas tips or plans would be great
thanks
wolf