HobbyKing.com New Products Flash Sale
Erknie's blog
Posted by Erknie | Mar 09, 2012 @ 10:26 AM | 2,680 Views
Turnigy Integrated PCB Micro-Quad project

Probably drill out the motor mount holes from 2mm to 3mm as 2mm screws a bit hard to come by. Also might have to change battery to 25C as motors each pull 5.8A max but that was measured on larger 6x3 prop. so might still be ok on 20C. Lots of good spots on the frame for LEDs

Project thread http://www.rcgroups.com/forums/showthread.php?t=1610229


My friend Clive doing a few flips on the completed micro-quad.

Turnigy microquad KK4.7X, stickscale3 (0 min 56 sec)



The HK ESCs proved too big for the frame arms, I am going to replace them with Plush 6A.