Watch the video to learn how much I spent at my LHS for some electronics for a 3D foamie. The parts and electronics in the video are GOOD quality, TRUSTED products that will not fail or die out easily. See about how much it would cost to get the same stuff from HK.
The whole point of me building this foamy is so that it will last a long time. So, I bought some quality stuff to go with it. Peace of mind.
Subscribe to support the RCFS and to see the Crack Yak build and get flown!
Finally getting CamStudio to work better with my computer (less lag in the video). In this flight I'm practicing some 3D with the ClearView SE Extra 330S 3D foamie model. ClearView SE is available for download at:
Music from beatsroyaltyfree.com
I will be buying a 3D foamie relatively soon. Brace yourselves for the 3D mayhem in the backyard! Thanks for watching and please subscribe to support me, DJO Producitons, and the RC Foam Show.
Another note: the goal is to hit over 50 subscribers (currently 32) by the end of summer! So if you can subscribe that would be great!
Motor bogged out at the end, I was using full negative pitch but the brushed motor is wearing down from all the fast 3D lately... I may go brushless eventually. Sorry about the bad filming, my brother is still getting used to following the tiny thing around. NO damage from the crash! But later on the mCPX did break. One of the servo's gears stripped. I'll try to get it back up and flying relatively soon.
The RC Foam Show Episode 1: Pink Bonsai DLG
Stay tuned for when I get some electronics and test this outside!
I will also be putting on a launching peg for discuss launches.
This plane will be flown mainly in my backyard.
More scratchbuilding to come; please subscribe!