Archive for November, 2012
Posted by quitcherbitchen | Nov 26, 2012 @ 01:38 PM | 6,012 Views
Posted by quitcherbitchen | Nov 17, 2012 @ 05:29 PM | 6,225 Views
ImagesView all Images in thread
cut out all the foam bulkheads to allow the carbon pushrods to move freely. Middle servo is the barn door dive brake servo. Right is rudder and left is elevator which is not hooked up yet
widened the stock servo location and added MG5065 servos for the elevator and rudder. Stock Hobby King servo is in the middle.
Taped my razor saw and knife to carbon rods to make the internal bulkhead cuts.
added 30cm 3.5 mm tubes to stock pushrods. This helps reduce flex and minimize friction. A-1s are prone to servo failure due to stock pushrods binding against internal bulkheads