HobbyKing.com New Products Flash Sale
sir_clive's blog
Archive for July, 2012
Posted by sir_clive | Jul 23, 2012 @ 06:16 PM | 3,687 Views
It's been 3 months and 1 week since my "looking for slope glider plans" post. Today, finally, my "Pimped OSG" is Almost Ready To Fly! Tomorrow the weather could just be good enough for a few tosses... fingers crossed that all the hard work actually pays out!

I was aiming at a slope glider somewhere between 1000 and 1500g of weight. As I put it on the scale today, I was surprised to see AUW 920g! Wow! For a 1.8m wing span, depron / balsa / plywood combination all covered in GFK, I was pretty happy with the result.

Unfortunately, the plane is SO tail heavy, that I had to stuck 140g of ballast into the nose to get the CG right. That brought me to 1060g - still nice, but I'm kind of disappointed I have to carry dead weight around.

Anyway, I'm proud of the result, over 1kg or not.

Tomorrow I just need to think of a way to secure the battery in the compartment, measure the motor current (it's an rctimer A2830/8 with a 9x4 folding prop on a 3S lipo), close that fuselage gap behind the TE of the wing, and I'm ready to go. I'll think of some nice covering for the wing servos later, if the plane proves to be airworthy. (Update: measured current was 19A, exactly as specified for the motor; and yes, she IS airworthy, you might want to check the first in-flight video here, it's being uploaded right now, if you are not reading this the moment I am writing it, it should already be there
"One Sheet Glider" pimped for the slope (5 min 4 sec)
)

...Continue Reading