Espritmodel.com Telemetry Radio
parkjungho's blog
Posted by parkjungho | May 13, 2014 @ 12:27 AM | 2,064 Views
I modify tarot T-2D gimbal to 3 axis gimbal.

Do not need any cnc part.
Just use 1~1.5t(mm) epoxy universal board.

You need blow tool and part.
1. 2.5mm and 3mm drill bit
2. electronic drill
3. m3 6mm , m3 8mm, m3 0.5t washer
4. gbm 3506H yaw aixs motor
- I use this : http://www.himodel.com/electric/iPow...low_Shaft.html
5. 3 axis simple bgc board.

◆ If you have old version t-2d.
- It's carbon plate gimbal mount.

1. make m3 hole east hole 12mm gap


2. yaw axis motor assemble


3. make gimbal assemble plate with epoxy universal board.
- two 2.5mm hole fit to tarot gimbal mount hole
- two 3mm hole fit to yaw axis motor hole.
...Continue Reading