SMALL - espritmodel.com SMALL - Telemetry SMALL - Radio
ppuxley's blog
Posted by ppuxley | Mar 02, 2011 @ 04:01 PM | 3,315 Views
I think I enjoy the building as much as the flying and even the frustration of the troubleshooting to get the thing working is great when you actually do work it out .

So the next project is a much smaller Quad . The rationale is -lighter, smaller, more agile and simpler,so I can start to practice aerobatics with less risk of damage.

A simple carbon fibre frame , with a Jussi v1.1 board and probably WMP only

My proposed specification is
Frame Mugi carbon fibre 12x2mm/25.4x.8mm http://www.mugi.co.uk/shop_product.php?id=441
ESC 6A Hobbywing Pentium http://www.giantcod.co.uk/hobbywing-...-p-403184.html
Motors GC 1406 Micro http://www.giantcod.co.uk/1406n-micr...-p-405246.html
Props 5x3 CW/CCW http://aeronautikhobby.com/epages/Ba...8&Currency=EUR
TX Frsky V8FT Tx Module http://www.giantcod.co.uk/frsky-v8ft...-p-405313.html
Rx V8 http://www.giantcod.co.uk/24ghz-frsk...-p-405233.html
Battery 2S 1000mah http://www.giantcod.co.uk/1000-2s1p-...-p-405656.html
Board Jussi v1.1
Pro mini
WMP


I will add photos as parts arrive and work progresses

10th March
Problem! the props dont fit properly on the 1406 motors. They nominally are 4mm ID ,but are only trully 4mm for the front half of the bore . the motor has a propsaver integral with the motor bell and that is only shouldered at 4mm at the base- consequence is that the prop doesnt engage securely on the propsaver and can float about-this causes huge vibration if you try to run the...Continue Reading
Posted by ppuxley | Feb 24, 2011 @ 04:38 PM | 1,846 Views
A Gallery of the photos that I used during my first...Continue Reading
Posted by ppuxley | Feb 24, 2011 @ 04:37 PM | 1,837 Views
My Specification
MWC 1.6 , default PIDs
1 x Quadframe QUAD002 (modified) http://quadframe.com/
1 x Loong max Tipple Lipo Battery 2700mah 3s 20C
4 x Hobbywing Brushless Motor 25amp esc speed controller
4 x XYH 28-30B 1050Kv 14A Brushless Outrunner
4 x 10x4.5 Props (2xCW, 2xCCW)
1x Jussi Shield V1.1 (Pull ups on board therefore internal pull ups DISABLED)
1 x GENUINE NINTENDO WII MOTION PLUS
1 x BMA020
1 x Arduino Pro Mini 5V 16MHz
1 x FTDI Basic Breakout - 5V New
2 x Turnigy LED strips and TIP31c Transistor

A very short video of the finished Quad, flying on a gloomy afternoon ,space was a bit cramped really.
Quad Test (0 min 47 sec)


Another vid of flying in the field opposite the house
...Continue Reading