HobbyKing.com New Products Flash Sale
DLGjunkyard's blog
Archive for December, 2011
Posted by DLGjunkyard | Dec 30, 2011 @ 05:44 AM | 14,615 Views
One example which can be purchased http://www.amazon.com/dp/B0015H2UR8/...SIN=B0015H2UR8


Inside the plastic cover there is a a small PCB with 2 male servo connector that shares + - and signal!
What I do is to remove the plastic cover and cut the PCB signal layer on the PCB. Then I solder a new signal Cable with a female servo uni plug. And there you have a good functional harness for the fuselage!


The diagram below is just to show the basic principal of a shared system V V V V V V V
Posted by DLGjunkyard | Dec 26, 2011 @ 06:00 PM | 15,930 Views
I think this set takes care of every thing up until preparing the skins/mylars.I will continue onto bagging next as time permits but I now need a assistant to take pictures once the resin gets mixed...Continue Reading
Posted by DLGjunkyard | Dec 24, 2011 @ 04:33 AM | 15,804 Views
a small description and diagram of how I cut kevlar hinges for my glider control surfaces

note:Read the text file down below . The diagram corresponds with the text file.The text should be read first to get the most out of the diagram