HobbyKing.com New Products Flash Sale
dale4040's blog
Archive for September, 2010
Posted by dale4040 | Sep 27, 2010 @ 01:01 PM | 1,802 Views
The instructions are pretty good, there's just a couple tips I would give to make it smoother for you.
--Cut off the extra bit of axle with the wheels on and fasteners attached to avoid cutting off too much.
--Try and have the main gear legs as short as possible, as in wheels as close to retract unit as possible. Make the nose gear leg long enough that you have to cut a bit from the stock plastic surround piece to make the wheel fit. This helps give the plane a more "up" attitude to make take-off easier because she is heavier and needs a longer take-off run with the new gear on.
Posted by dale4040 | Sep 26, 2010 @ 11:38 AM | 1,747 Views
Habu retracts (1 min 2 sec)


Ready for air testing
Posted by dale4040 | Sep 22, 2010 @ 05:48 AM | 2,433 Views
Retract install went great but made one rookie mistake cutting the axles a tiny bit short and there's not enough room for the aluminum stops at the end--oops