Shop our Airplanes Products Shop our Surface Products
streborz's blog View Details
Posted by streborz | Feb 19, 2016 @ 11:21 PM | 1,946 Views
13hrs into the build now and I hope I'm about half way through. Here are some more progress pics....Continue Reading
Posted by streborz | Feb 18, 2016 @ 12:22 AM | 2,174 Views
Doesn't look like much more has been done. I did have to study the plans for a while figure out some things in the bellcrank mount area and control linkages. Trailing edge and sheeting on TE are done and got lots of sanding finished.

About 10hrs now.
Posted by streborz | Feb 16, 2016 @ 11:01 PM | 1,597 Views
Wing laid up.

6hrs to this point.
Posted by streborz | Feb 16, 2016 @ 07:54 PM | 1,596 Views
3hrs to get to this point.

That's an OS 40 Surpass.

The motor mount slot was opened up to accommodate the extra length and weight of the engine.
Posted by streborz | Jan 21, 2012 @ 04:33 PM | 3,459 Views
Newly acquired GMP Cricket ready for restoration. I traded a RX ready Swizzle Stick for it. Can hardly wait to fly it, it should be fun.

Update: I got radio gear in it and am now ready to try it out. On the first spool up one tail grip had broken which was a major setback for me. I had no spares. To make a long story short, I robbed the tail grips from my night flyer, a Raptor 50 v2, and the grips work just great on the old hub and bearings. $6.50 repair. Yeah!!

After figuring out how to center and how much travel the tail rotor would need, I put an E-Flite EFLRG110HL gyro / Futaba s9253 in it from the scrap box. It took a little while to figure out how to set it up for HH mode. After fiddling with that for a few evenings I did get it outside to try to hover. It was dark outside and I only had moon light to help me see but it was a promising hover. The tail was solid. Now just waiting for lighter winds. Winds have been 20-30mph here recently.
Posted by streborz | Jan 21, 2012 @ 04:03 PM | 3,896 Views
Avistar Electric Conversion:

Headsuprc.com Powerup 46 Motor
HobbyWing 70A Platinum HV OPTO ESC
MPI BEC under custom battery tray
APC 11x8e Thin Prop
Motor mount standoffs, screws and blind nuts are from Ace Hardware
Futaba s3003 standard servos
Spektrum AR7000 RX powered buy Zeus 2s 350mah lipo
I use batteries from a Trex 500 for power
Spyder 6s 30c 3300, Volts 6s 65c 3300 and Turnigy 6s 2650

The CG is right on with these packs and you get about 4:30min pushing a little hard and over 7:00min cruising around. The packs come down right at 3.8v per cell. Weight is about 5.6lbs. depending on the pack.

Output is: 1500 Watts at 60amps
Posted by streborz | Jan 10, 2010 @ 07:19 PM | 4,353 Views
This is a picture of the Foamie that I built for my friends birthday present. It was test flown today (1-10-10) and went to its new home today.