New Yak

Well I need to get an airbrush, but all I had was some of the krylon shortcut stuff... So I gave it a quick try (about 15 minutes) and here is how it looks.

Corona RX came with no antenna Does anyone know where it goes?

I am getting ready to sell these control horns. Still only designed for 3mm depron, but they are extremely tough and will hold fine in 6mm depron, fanfold, and even 9mm EPP. Great lightweight control horns for a low price. Check soon at www.SpecialTllc.com for our special low introductory price on your SpecialT hardware.
Brian

Motor mounts can be redesigned to fit your motor for an extra setup fee.

Designed it up in solidworks, only designed for a grayson 2212-06 will design it for others later

I will get more pictures soon

I got my first flights in with a glow plane today... It all went well until the third flight when the engine died. I only broke my prop after gliding into some tall grass. I actually liked it. Will electric get pushed out for glow? Find out next time.

I was given an Alpha 40 trainer with radio and just about everything needed to fly. I picked up some fuel and ran the engine up no problem, even though it was sitting for about 3 years. Now to find time to go fly it. Also my first glow plane.


I need a different camera other than my cell phone...

I was on my second flight, the first one was short due to the wind. So I took out the Funtana after it calmed down. I did a few rolls and loops and I was about to bring it in when the motor mount flew off chopping off part of the nose. My first E-Flite kit and this happens. Someone is getting a call tomorrow.

Here is a link to a video as well http://www.brmihi08.com/DSCF2724.AVI...Continue Reading

Just some pics of my new Funtana...Continue Reading

I made up a little Mig 29 variable thrust from www.rcsuperpowers.com 's plans. I dropped the wingspan to 20 inches and it uses 3 hs-55's and a 1500kv UH motor with a 5x5 apc prop. This plane was also cut with the CNC. I haven't decided on the battery yet.

Update: I got a chance to maiden it, and it seemed to do fine. I need to get some new batteries because I am still using batteries that are over a year old and have a bunch of cycles on them. Once I get a new battery I will try to get a video up

this is the Sumo 3d designed by Firetrappe, and then I cut it out on the cnc. I messed up a few things though.

I got a chance to work with the CNC Router some more, I made a few control horns and motor mounts for the UH motors. I might try and sell some....Continue Reading