THe return after a swim !!!
Like You saw in my last vid, my FPV summit fall in the water and all electronic stuff go in it !!! 
I remove it from the truck , open all cases and let it dry all !! Luckily , everything rework again !!!!!
Here a vid i did after the nightmare :
Like you can see, the quality on the tx rx is a little bit not super good !! Because my antenna connector on the tx is damage, not because of the water fall down , but i pass under an obstacle too low and the antenna stuck on the object and damage my connector !!!
Martin_y gentilly ask me to repair it . so i sent it to him and it be better !!!
Thank s a lot Martin !!!!

I remove it from the truck , open all cases and let it dry all !! Luckily , everything rework again !!!!!
Here a vid i did after the nightmare :
| FPV Traxxas Summit Going nowhere in the wild (11 min 24 sec) |
Like you can see, the quality on the tx rx is a little bit not super good !! Because my antenna connector on the tx is damage, not because of the water fall down , but i pass under an obstacle too low and the antenna stuck on the object and damage my connector !!!
Martin_y gentilly ask me to repair it . so i sent it to him and it be better !!!
Thank s a lot Martin !!!!
FPV Traxxas Summit part next 2 !!! loll
Here a vid on daylight with my new cam !!!
I did another vid Last week But it finish badly a little bit !!!!
...Continue Reading
| Traxxas Summit FPV project part 4 (4 min 17 sec) |
I did another vid Last week But it finish badly a little bit !!!!
...Continue Reading
I got it , my new cam and the first impression are good !!!!! I install it yesterday night and try it , wow not bad in the dark , but today i ll try by day and check if the grass would be gray again !!! lolll !!
I put a vid on Vimeo that i d done yesterday night !!!!
Here some...Continue Reading
I put a vid on Vimeo that i d done yesterday night !!!!
| Traxxas Summit Fpv project Part 3 (4 min 2 sec) |
Here some...Continue Reading
My FPV summit Project keep going !!!!!
I bought a new camera from securitycamera2000 and waiting for it !! I begin to install my mamba monster 2200 kv combo in my summit because :
- It got the lipo cut off automatic
- it got more torque than my 775 titan
- With the thermostatic fan , it keep it running cool at slow speed
- The ESC got a Drag brake
The only thing is not good about the switch is the mamba is only water Resistant , and the EVX is full water proof !!! But you know , all my fpv stuff are not water friendly , so i ll keep away from water !!! lollll !!!!
I ll put a 12 teeth pinion on the motor and a 68 spur to give me a ratio of 82 to 1 on the first gear !!!! top speed , hum 6 - 7 mph !!! lolll !!!! But you know when You explore and crawl over obstacle , you don t need speed , but torque !!! And in second , it will be a around 20 mph !!!!
That setup will give about an hour of run time with a 5000 mah lipo 3s !!!
Here a little vid i done with my go pro on board of my E revo And my Mini E Revo VXL !!!!!
...Continue Reading
- It got the lipo cut off automatic
- it got more torque than my 775 titan
- With the thermostatic fan , it keep it running cool at slow speed
- The ESC got a Drag brake
The only thing is not good about the switch is the mamba is only water Resistant , and the EVX is full water proof !!! But you know , all my fpv stuff are not water friendly , so i ll keep away from water !!! lollll !!!!
I ll put a 12 teeth pinion on the motor and a 68 spur to give me a ratio of 82 to 1 on the first gear !!!! top speed , hum 6 - 7 mph !!! lolll !!!! But you know when You explore and crawl over obstacle , you don t need speed , but torque !!! And in second , it will be a around 20 mph !!!!
That setup will give about an hour of run time with a 5000 mah lipo 3s !!!
Here a little vid i done with my go pro on board of my E revo And my Mini E Revo VXL !!!!!
| E Revo Bruhless Mamba Monster 2200 kv combo (3 min 31 sec) |
...Continue Reading
Test record with my set up !!!
I finally got my adaptor to connect to my computer and recording vid of my FPV drive !!! It will give u and idea of the bad quality i got with that camera !!! It s not the first i bought like that, the first was perfect , give me a super quality , but one of my friend need it for his barn , so i sell it to him , and after i bought another one ( this one ) and beurk , no good , very very no good !!!!!
AH just one thing, i have to retune the suspension , the front is too stiff , adn the back too soft !!!! next step !!! Lolll
AH just one thing, i have to retune the suspension , the front is too stiff , adn the back too soft !!!! next step !!! Lolll| Traxxas Summit FPV Projet part 2 (2 min 42 sec) |
New test with my new setup !
I did a new test last week with my setup almost done !! First i been very suprise about the range of my 2.4 ghz radio futaba 4PK , i drive about 500 meters before losing signal , when the truck stop (because lost signal) i lift the control more in the air and back up, turn back , return to me !! I install a garmin Etrex legend on the truck and it writen 1 km on it when i d check it after turning back to me !!! Koollll !
For sure i want more , so i check for a better antenna or something else !!!! If somebody know how to improve the range with my radio , feel free to write it to me !!!
I did a vid with my go pro hero on board , but i didn t drive it in FPV because , my go pro is not the HD version and i can t do live vid with , but it give me an idea how it look with a wide angle view !!!!
For sure i want more , so i check for a better antenna or something else !!!! If somebody know how to improve the range with my radio , feel free to write it to me !!!
I did a vid with my go pro hero on board , but i didn t drive it in FPV because , my go pro is not the HD version and i can t do live vid with , but it give me an idea how it look with a wide angle view !!!!
| Traxxas Summit Go Pro Hero On Board (2 min 23 sec) |
I install all the component on the Summit . For my first experience, i bought the tx rx and the camera on ebay !! I know it s not the best quality, but for a beginning , it s good !!! The little camera got a night vision on it , i like that because i like to drive by night !!! I m a little bit disapointed about the image quality !! I check for the KX 191 camera for the next step ... For me, this body is almost finish !! I think i will do just some minor change on that projet, because i got another projet in mind that i will begin soon !!! A BIGGER Summit !!!!!...Continue Reading
I put some pictures of most all the rc truck i got since the beginning !!! Some of them are gone and other not !!!...Continue Reading
Hi Everybody !!
I bought a traxxas summit on last christmas holiday and have a lot of fun with it all winter !!!!
After i found on You tube the FPV driving !!! WOW !!!! I want that !!!
So i begin to build a body that i can put a camera , transmitter and every thing i need for FPV !!!!
Here somes pics !!! more to come and vids too !!!
...Continue Reading
I bought a traxxas summit on last christmas holiday and have a lot of fun with it all winter !!!!
After i found on You tube the FPV driving !!! WOW !!!! I want that !!!
So i begin to build a body that i can put a camera , transmitter and every thing i need for FPV !!!!
Here somes pics !!! more to come and vids too !!!
| Traxxas Summit FPV Projet part 1 (3 min 35 sec) |


