HobbyKing.com New Products Flash Sale
krise's blog
Posted by krise | Oct 23, 2013 @ 10:24 AM | 1,934 Views
A member on this board was needing some help setting up RVOSD5 switches on his stock turnigy 9x, so I made this little how-to for him. He suggested that I put it in my blog, as maybe it will help someone else too. So, hopefully someone out there in TV land finds this useful.


So I had a look at my settings in the 9x stock firmware. To get the 3 position switch to work, you have to go to the menu "PROG.MIX" and make 3 mixes.




Mix 1 should look like this:
...Continue Reading
Posted by krise | Jan 12, 2013 @ 11:47 PM | 1,646 Views
Originally Posted by Vantasstic
Sorry to jump in without fully going through all the previous posts. Since you mentioned your system was upgraded, the LED sequence is different on a V1 with V2 upgraded firmware. Just in case you haven't seen it, here's the sequence for the system:
On the upgraded Version 1 systems the new LED sequence is:
Hold down the button on power up:
3 - 8 Seconds: RED Flashing LED Micro Power Mode
8 - 13 Seconds: GREEN Flashing LED Binding Mode
13 - 18 Seconds: Alternating GREEN and RED LED Calibration Mode
18 + Seconds: LED Goes OFF - Change UNIT ID