HobbyKing.com New Products Flash Sale
gdwhite's blog
Posted by gdwhite | Feb 19, 2014 @ 08:10 PM | 1,732 Views
Had a great day off of work on Monday - went flying with my Radian. The Radian had not such a good day - lost sight of it while flying over head looking directly at the sun - it then ran into a mesh fence next to the goal posts at the field I was flying at (Mount Torrens Oval). Should be able to fix it.

Name: 20140217_145024.jpg
Views: 0
Size: 245.2 KB
Description:
Posted by gdwhite | Feb 14, 2013 @ 04:53 PM | 2,441 Views
Attached is a description of a simple full house glider setup (4 wing servos) for Turnigy ER9X Firmware. It should be able to be adapted to the original Turnigy 9X V2 firmware.

I have used this on my 3 metre Balsa glider - photo attached.

My transmitter is a Turnigy 9X, flashed with Frsky Telemetry ER9X Firmware.
Posted by gdwhite | Nov 07, 2012 @ 05:35 PM | 2,573 Views
Attached are reference screen grabs for EEPE - setup for a fullhouse F3B model with 3 flight modes - Speed, Thermal and Launch...... Setup according to Erik at the old Gliders.dk website - original link still works... http://users.cybercity.dk/~cws19202/...der_wi_eng.htm

Also attached is reference calibrations for my ER9X transmitter.
Posted by gdwhite | Nov 05, 2012 @ 10:05 PM | 2,513 Views
Attached is a file describing the mixing setup for an ER9X transmitter controlling a full house glider - for F3B has settings for each task. I have placed this here for my reference so I dont forget how it was setup.

This is my attempt at F3B on a budget - this transmitter cost $54 and I have added a Frsky model with telemetry (displays receiver voltage on transmitter) which together with a receiver was about $40.

Now I just need to make a budget glider.
Posted by gdwhite | Aug 22, 2012 @ 10:32 PM | 2,677 Views
An Apogee (Mark Drela airfoils and plans) wing cut last night. Trailing Edge is not yet trimmed. Foam used was from the side of a Fruit and Veg Polystyrene box I got for free down at the local shops.
Posted by gdwhite | Aug 22, 2012 @ 08:12 PM | 2,867 Views
Foam cutter is partly working - I am using Ankers Stealth Plane Works "Foamcutter" - a highly configurable standalone package. Hardware is home brew made using one PIC16F88 per axis, each axis also has a current controller and $6 ebay stepper output driver. Power supply also from Ebay, 24VDC switch mode 5Amp ( added a 5Volt regulator to power the Pic's).
Cutting wire is resistance wire (about 0.4mm) from a local electronics store. The constant current source is set from 0.9A to 1.5A depending on the axis speed and is powered by a 3Amp 24Vdc LED power supply.
Posted by gdwhite | Apr 25, 2012 @ 09:37 PM | 3,842 Views
Got a Hobby King Altimeter this week. Here is a log of coming to work this morning via the Freeway. I will try it in my Radian in a week or two.