Diet for the Aiptek Pen cam
Cut the weight from the pen cam from 114 grams down to 48 grams by hacking off the heavy case and soldering in 2 AAA instead of the AA.
-
Views: 208
Snap the housing open and take out the board. You will have to unscrew two screws that hold the lens to the image sensor. once off the board put the lens back over the sensor and put two dabs of glue on the ends of the screws over the sensor. -
Views: 139
Cut 6mm piece of depron to fit as a backing. -
Views: 152
2 AAA = 22.7 g where 2 AA = 45.9 G. or any light combo of 3v. -
Views: 135
snip off battery leads on board and solder in a + and - wire. pull leads out through new foam front and solder to battery + and -. be sure to solder wire on bottom connecting the battery ends. (Use rechargable batteries) -
Views: 120
pen cam still works -
Views: 144
total weight, 48g -
Views: 133
installed in a light depron flyer. -
Views: 145
under view of cam
Bomb Bay door on YAK 54
Modified Tak 54 with bomb bay door. Balsa used from crashed Edge 540, servo from crashed Trex 450....Continue Reading
FREE Dual tail mod in 10 min
After the first trial I suggest using a CA that has a little more time to work to adjust the position or use an Epoxy. On my first run it dried to quick and the alignment is slightly off. I doubt it will have any adverse effect but a little extra work time would be good to get a piece of paper between the gears to be sure they mesh with the right clearance.
-
Views: 298
Match up where it needs to be sanded flat with the dremel. Mark with a sharpe where it needs to be sanded down. Sand and check, then sand and check. The closer they match the stronger the bond will be. -
Views: 205
with the gears meshing smoothe mark a spot to drill a 1/16 hole in the lower tail mount. A piece of CF rod will add lateral stability. Carefull not to drill into the tail wires. -
Views: 217
Originally I used CA to secure the two pieces tegether but using fast dry epoxy would give a little more time to adjust the correct postition. Put expox on the mount and ont the CF rod. Press into place then while holding the mount in place turn the gea -
Views: 227
Solder the power and ground. -
Views: 242
Cheap, light tail mod with removable motors. You can adjust the pinion position with the set screws in nessessary. Total time 10 min
