Almost complete, needs some electrical measurements (amps, watts, etc.) and a spinner. Will fly it initially on a 2S1P TP 2100 lipo, then probably go to a 3S1P 2100 pack. This would require some modification of the battery shelf I built into the plane.
Power: MiniAC 1215/20
Prop: Graupner CAM 6x3 Folding Prop
Servos: (4), all Hitec HS55's
Receiver: FMA M5V2
ESC: CC Phoenix 25
Full 4 channel
If this drive system is overloaded, I might swap it out for a Mega 16/15/5 if it will fit. Could also run gear drive on the MiniAC motor but I understand that can get real noisy.
Won't maiden the plane till the spinner is obtained and installed.