HobbyKing.com New Products Flash Sale
Whizgig's blog
Posted by Whizgig | Feb 01, 2012 @ 06:29 AM | 1,381 Views
DH9116 Swashplate Level and Link Adjust Mini-HowTo / Posted by stormforce / Today @ 09:56 PM / 38 Views / 0 Comments / Reply
Factory lengths for both servo linkages. To increase in length, turn clockwise (left). To decrease in length, turn anti or counter-clockwise (right).

The longest linkage with the outside (O.D) points of a digital vernier caliper should be 36mm (exactly 36.61mm), and with the inside (I.D) points of a digital vernier caliper the total overall length is 42mm (exactly 41.59mm)

The shortest linkage with the outside (O.D) points of a digital vernier caliper should be 26mm (exactly 26.32mm), and with the inside (I.D) points of a digital vernier caliper the total overall length is 32mm (exactly 31.21mm).



------------------------------------------------------------

The basic mechanical trimming up of the swashplate is as follows;

Remove the canopy and find the plugs to the tail motor and main motor on the pcb and pull them out (making note of where they go), therefore disconnecting both the motors from the heli's battery power source. Connect the battery to the heli, turn on your tx and switch on / power up the heli and allow the heli to bind or sync with the tx, the servo's should flutter when it is bound. Centre all the trims on the sticks on the TX and...Continue Reading