HobbyKing.com New Products Flash Sale
kevinhines's blog
Archive for February, 2009
Posted by kevinhines | Feb 22, 2009 @ 02:40 PM | 8,121 Views
Here is a description, with some videos, of the flaps I made and have been flying on my EasyStar RC airplane models.

Why I made flaps for my EasyStars: I wanted to be able to land slowly and gently, in small, confined areas, with my FPV EasyStar, and the flaps have helped me a lot with this.

I like the flaps so much, that I now move the one set of wing-halves, with the flaps, back and forth between both of my EasyStars, so that I always have the flaps available. :)

Since most of this info has been discussed in the EasyStar forum, I decided to post it here, in a FAQ/discussion format. Perhaps someday I'll edit all of this down into something more concise, but until then, here it is.

Thanks to all of my friends who have encouraged me along the way with this project.

Who Taught Me: I especially must thank Teccer & Marckossa, for leading the way with building flaps for their EasyStars, and for guiding me through this process... and for allowing me to copy their flap designs... Thanks!

I edited some of the postings, for conciseness.

If I quoted you in a post, and you'd prefer not to have your name in this FAQ, just let me know, and I'll remove your name, and/or what you wrote, from this FAQ.

I hope this is helpful information,
Kevin

A Few Details:
1. The dimensions of my EasyStar flaps are copied directly from Teccer's excellent design:
-start 3” from fuselage
-14” long
-1.75” wide
-fully deploy downward to about a 45...Continue Reading