So I finally picked up my 2nd j10 NPS kit from aeromicro yesterday, so I could finish her all up. I made a mistake assembling the canards on the first kit and mangled some of the pieces
All my fault, just in too much of a hurry.
Im using a HET 6904 fan w/ a generic United Hobbies brushless motor. Im planning on running 4s 2250 if I can get her to balance (well find out after dinner here). It pulled 501 watts on a fresh pack after 10 seconds. 3s seems pretty solid as well, Ill run numbers on it as well.
While taxiing the plane up and down the street with a 3s pack, gusts of wind tended to knock the plane over, and caused some slight foam damage. I repaired it, but the wingtips are a bit fragile.
All in all, it was a fun build (a bit time consuming compared to other GWS kits Ive done), but the kit came w/ extensions and all other required hardware (minus servos, ESC, etc of course). Hopefully Ill get to maiden her tomorrow morning, and someone will be around to snap some good pics
Don