Posted by nick_75au |
Feb 06, 2010 @ 03:29 AM | 11,040 Views
I read Glynn Guest's article on simple control for steam engines posted in the forum, and seeing as I had already built the clamshell part I thought about trying it on them, so I grabbed some PCB material and fitted the servos to it and soldered the outer tube to the PCB copper surface. Made up some copper wire servo linkages(will bend if there's a problem), turns out this was a good idea as getting the buckets to sit correctly was a bit of trial and error.
Moving the servos to the centre improved the operating of the system, both servos in line with the centre may be even better.
the system requires a V-tail mixer to work correctly