HobbyKing.com New Products Flash Sale
OrangeBird's blog
Posted by OrangeBird | Feb 26, 2015 @ 08:34 AM | 1,599 Views
Posted by OrangeBird | Feb 25, 2015 @ 02:50 PM | 1,723 Views
Posted by OrangeBird | Feb 25, 2015 @ 11:56 AM | 1,495 Views
Posted by OrangeBird | Feb 24, 2015 @ 10:34 AM | 1,704 Views
# 25 a

TX V912 Mod for Trainer



# 25 b

TX V912 with TX Trainer ( electronic switching with I/C )



# 25 c

Features with Master Tx / Slave TX

...Continue Reading
Posted by OrangeBird | Jan 06, 2015 @ 01:53 PM | 2,180 Views
V912-4 channel flybarless V2 FP

Added new servos FX071c ( on the side of heli )

Photo # 150



Photo # 150a

Prepare your frame to receive the FX071c servo or Tower Pro SG90 servo



Photo # 150b

...Continue Reading
Posted by OrangeBird | Dec 24, 2014 @ 11:09 AM | 2,560 Views
Translated from Russian into English

Click here if you will start at section # 6

The second that I highly recommend to do with the equipment - to make this dish.

The antenna in OEM TX, just a piece of plastic ( fake antenna ) , and the signal is transmitted piece shielded multicore wire which is in the housing. Purified from the end of the wire screen is 31,25mm and the transmitting antenna.
The range of this antenna is not tricky to my measurements is about 200m. This distance is sufficient with a huge margin for the flight, but !!! This all works under normal conditions without any external interference.
For a long time I was not worried about this issue, until I started to fly on a school field near high-voltage power transmission line which passes. And then began a loss of communication at a distance of 50-60m is not very nice. At the same time on the same field range of the remote was about 200 m on the ground. And in the air fared much worse. So I decided to put on a full remote antenna.
For this purpose, the near-market radio antenna was purchased for Wifi router by 2 dB, and SMA times it, to install the antenna.
Part of the OEM mount fake antenna I cut, pre-parse it. In this attachment I put SMA connector by screwing it on top of the nut and pre-soldered to it lead from the transmitter module. The central core to the center pin and the braided shield divided into two honor and solder the connector housing.

The result is a definitive yes. Losses...Continue Reading
Posted by OrangeBird | Dec 11, 2014 @ 01:39 PM | 3,427 Views
Translated from Russian into English


WLToys V912 - further higher faster.
WLToys V912 4-channel FP flybar helicopter 200 size.




You can order here

For other photos go to this thread :

http://www.rcgroups.com/forums/showp...postcount=7884

Helicopter for novice pilots, and so it can be safely attributed to the section more toys than in section serious devices.
However, for the initial dating, this is a very worthy machine.
To date, a version WLToys V912 with brushless main motor, and this version is more preferable, although it is slightly trimmed in functionality, and it is not possible to connect the camcorder, bubble machine, water cannon and crane.

You can order here

If at the time of reading this post you have not bought WLToys V912, or bought and already break it. I advise you to pay attention to the other models of the same size, but without flybar, FX071c

You can order here

This model flies much better than v912. Workmanship she also higher. Well, no flybar makes it reliable and durable.

In this post I want to talk about WLToys V912, so on just about it.

Most:
- Not expensive
- Very strong and stable.
- Spare parts are very cheap and available in many places.
- Flies out of the box, but no wind.
- Pretty good control for toys this level.
- The presence of additional accessories, camcorders, apparatus bubbles, water cannon and crane.

disadvantages:
- Quality of performance and balancing of the box is poor.
- Out of...Continue Reading
Posted by OrangeBird | Oct 23, 2014 @ 11:21 AM | 4,557 Views
V912 4 channel flybarless FP



Nose weight added 7 grams
Weight FX071c 288 grams with EOM battery
Weight V912 flybarless 312 grams with EOM battery
TX Feilun Toys 4 channel 2.4 Mhz
RX Feilun Toys 4 channes 2.4 Mhz FX071r




With tail assembly FX071c and you can order at :

Tail Accessories...FX071c-13 ...SKU149470

Video front of my house

V912 Flybarless (1 min 14 sec)


Video back of my house

...Continue Reading
Posted by OrangeBird | Oct 01, 2014 @ 12:16 PM | 4,911 Views
VELCRO Then hold RC Lipo Battery Low Voltage Monitor Alarm Tester Buzzer

You have just one RC Lipo Battery Low Voltage Monitor Alarm Tester Buzzer but more heli . Just use velcro to move to other heli.

Photo # FX071c-36



************************************************** *************************************************

RC Lipo Battery Low Voltage Monitor Alarm Tester Buzzer

Photo # FX071c-37




************************************************** *************************************************

1S-8S-Li-po-Battery-Voltage-Tester-Checker-Indicator-Monitor Buzzer-Alarm

You can adjust the low level voltage.

Photo # FX071c-38

...Continue Reading
Posted by OrangeBird | Jun 30, 2014 @ 04:32 PM | 7,351 Views
Posted by OrangeBird | Feb 28, 2014 @ 03:49 PM | 7,875 Views


Abbreviations in R/C

A = Amp (ampere )
ACC = Accelerometer
AGL = Above Ground Level
Ah = Amp Hour (1000mAh)
AKI = Anti-Knock Index
ALT = Altitude
AM = Amplitude Modulations
AMA = Academy of Model Aeronautics
AOA = Angle Of Attack
ARF = Almost Ready to Fly
ARTF = Almost Ready To Fly
ASAP = As Soon As Possible
ASL = Above Sea Level
ATV = Adjustable Travel Volume, a.k.a. servo endpoint.
AUW = All Up Weight
AVCS = Angular Velocity Control System
BB = Ball Bearing
BD = Belt Drive
BEC = Battery Eliminator Circuit
uBEC = Ultimate Battery Eliminator Circuit
BG = Banggood.com
BL = BrushLess
BNF = Bind and Fly
BO = Back Order
BOL =
BTW = By The Way
CA = Contact Adhesive
CA = Cyanoacrylate
CC = Credit Card / Castle Creations/ Cubic Centimeter
CCPM = Collective/Cyclic Pitch Mixing
eCCPM = electronic CCPM
mCCPM = mechanical CCPM
CNC = Computer Numerical Control
CF = Carbon Fiber
CF Tail Boom = Carbon Fiber Tail Boom
CG = Center of Gravity
CL = Center Line
COG = Center Of Gravity
CP = Collective Pitch
CW = Clock Wise
CCW = Counter Clock Wise
DB = Decibels = sound pressure level
DD tail conversion = Direct Drive tail conversion ( see photo # 60 below )
DMM = Digital MultiMeter
DPDT = Double Pole Double Throw
D/R = Dual Rates
DSM = Digital Spectrum Modulation
EPA = End Point Adjustment
EPS = Expanded Polystyrene
ESC = Electronic Speed Controller
FBL = Flybarless
FF = Freeflight
FFF = Fast Forward Flight
FG =...Continue Reading
Posted by OrangeBird | Feb 12, 2014 @ 05:47 PM | 9,261 Views



************************************************** ***************************************

Canopy MJX F45 fitted on V 912 by headlessagain

Photo # 50


************************************************** ***************************************

By Doctor_X

Photo # 51

Finished up the Xtreme CNC swashplate on my 912. As with all my parts, the gun-metal anodized finish was removed and the piece was mirror polished prior to installation Looks and flies great !

...Continue Reading
Posted by OrangeBird | Dec 01, 2013 @ 11:44 AM | 10,300 Views
<
<
WOW WOW -----THE SKY IS
CLEAR----YES


-----------------------------------------

Navigation LEDs on V912

Photo # 30

...Continue Reading
Posted by OrangeBird | Aug 07, 2013 @ 09:49 AM | 14,806 Views