The bus frame is 3 strands of 1.2mm copper wire twisted together and soldered. The tape used for insulation is called Isobond Elastic Self Amalgamating Tap. The two connector terminals are facing down through the bottom of the base plate to connect to the battery below.
Posted by SkippyTBK |
Nov 01, 2014 @ 09:13 PM | 1,568 Views
DJI have now removed the recommendation from their NAZA M web pages and wiki that the NAZA M V2 is recommended and suitable for a Spreading Wing 800
Apparently in spite that its been a recommendation on their web pages for a few years now, DJI advises me they do not support the NAZA M as suitable for a Spreading Wing 800 or any other 800 size frames or frames over 600 size.
You can read more bout this discussion here on RCgroups and here and http://www.rcgroups.com/forums/showpost.php?p=29836577&postcount=134"]here[/URL]
Seeing we have already purchased this equipment combination as was a suggested recommendation by DJI on their web site, and now they are advising us otherwise, we are requesting that DJI to credit or refund us the cost of the NAZA M so that we can purchase a suitable flight controller for our 800 size airframe. You can follow our discussion with DJI here
I am setting up this thread as free open space page to share our ideas freely on Openpilot topics and particularly for many who I see, including myself, that have been unfairly banned from the Openpilot forums because certain administrators there simply disagree on a point of view, or who do not want to have any negative truths disseminated about the Openpilot system.
This will not only give those who have been banned from the OP forums and who have invested time an money into the Openpilot systems a place to continue to share ideas and to help one an other for support without fear of the tyranny of being banned again, but also a forum space that is transparent and open and to sharing both the good and the bad about Openpilot systems so that any new comers to this system are also full aware what they are getting into.
This being said I personally believe the Openpilot system is one of the best platforms in both hardware and software development currently available and credited to be given to all those developers who have spend enormous amount of time and funds into its development. Well done to the Openpilot development team.
lastly for those who have been burnt by the Openpilot administration, please try not to use this thread as a place to simply vent out your anger and frustrations. Keep it civil and constructive and factual as possible.
This thread is to include any discussions on Openpilot firmware and software, Revo, CC3D and any other Openpilot hardware and also including the new ArduPilot32 on OpenPilot Revo firmware that now give OP Revo full GPS autopilot flight capabilities.
Welcome all to the Openpilot Outcasts and Renegades thread.
John ( Banned IDs on Openpilot Forum Holden11 and SkippyTBK )
Malaysia, Federal Territory of Kuala Lumpur, Kuala Lumpur