A build, or should I say, move log will follow soon.
Waiting for the parts to complete my new Y6 frame , designed, brought to life and partially based on my requests by Dialfonzo.
The overall idea was to change the F550 frame to something generating less vibrations. F550 (as everyone who uses it knows), has plastic flexible arms, which are durable and lightweight but bend and shake due to torque and p-factor + propwash in general.
I was initially thinking about replacing the F550 arms with CF tubes but it turned out to be harder and more expensive than I thought. None of the standard available clamps will fit the frame because not only it uses a strange screw hole spacing but also the holes in the bottom plate and upper plate are not lined up. I designed custom clamps that would probably do the job but 3d printing of a single clamp would cost around 35$-40$.
Another idea was to use a sort of arm braces. Several F550 users went that way with pretty good results. It's described in this
thread.
I finally decided to move to a completely new frame,specifically designed to fit all DJI's electronics and motors. Some people ask me why, instead of just building a new copter from the scratch, I'm still insisting on using all the DJI stuff. Back when I was flying helis this was the kind of mistake I made. In effect, I had 3-6 helis sitting in my garage, never to be used again since I was playing with my new toy.
I usually use 1 rig and don't need to upgrade to a
...Continue Reading