Ok I will try and keep this simple and clear so everybody can understand it. If anybody has any questions just ask me.
Start with a model that hasn't been used or reset your model to factory settings to make sure we don't have any old settings kicking around. Click once on the model you intend to use scroll down to copy/reset click once scroll down click on reset scroll over click on yes.
1 First step we are going to have the plane sitting in front of us and will be looking at the plane from behind.
2 plug the esc into throttle port
3 plug the right servo into the aileron plug on the rx
4 plug the left servo into the AUX1 port
5 bind the rx and test the controls. Only the right elevon should move and only when you move the stick right and left. Right stick and the right elevon should move up. If it doesn't you need to reverse the servo. (To reverse servo direction from the main screen click once scroll down to setup list and click once scroll down to reverse and select the channel you need to reverse. Aileron channel) When you move the stick up and down nothing should happen. No left elevon movement at all. If this isn't exactly what happens double check your connections. Dont worry about the left stick at all. Its happy we don't need to do anything to it.
6 Setting up your radio.
7 Click the scroll wheel once and scroll down to Setup List. Click on setup list.
8 Scroll down to Wing Tail Mix and click on it
9 Scroll down to Dual Aile
...Continue Reading
