HobbyKing.com New Products Flash Sale
Tahoe Ed's blog
Posted by Tahoe Ed | Aug 10, 2014 @ 11:20 PM | 5,552 Views
I had to reset the landing gear. If you look around and follow the wires coming from each leg, you will see they plug into a R & L and there is an IN on a small block. Next to the IN is two little holes. The one closer to the L & R has a little button inside the hole. the next one to the right of that hole is a light. It's likely that it isn't showing any colour.

This fix will take two people.
1. Make sure the gear switch is in the DOWN position
2. With the power off. use a small screwdriver or paper clip and push in the button.
3. Set up the drone so that that the landing gear aren't touching the ground. I rested two of the arms on a desk and supported the drone via one of the other arms. THEN...
4. Push the button and hold it there while the other person plugs in the batteries.

It should go through a reset and then you will see the little light come on. You should be back in business! Try the landing gear lever and with any luck you'll be back in business.
Posted by Tahoe Ed | Jul 15, 2014 @ 11:56 AM | 5,540 Views
Posted by Tahoe Ed | Jun 20, 2014 @ 01:11 AM | 5,352 Views
Thanks to user Aitrui for putting this together. He did quite a bit of research to do it. Maybe it will help others.

Posted by Tahoe Ed | May 23, 2014 @ 06:58 PM | 7,438 Views
Here is the procedure to reset the gimbal when it bricks on upgrade.

Posted by Tahoe Ed | Apr 24, 2014 @ 08:43 PM | 7,440 Views
A user came up with a procedure for resetting the BTU on the Ground Station. Here is the link;

Posted by Tahoe Ed | Apr 10, 2014 @ 12:48 AM | 6,748 Views
This appears to be a solution for those who are frustrated with Ground Station's lack of Photogrammetry.

Posted by Tahoe Ed | Mar 24, 2014 @ 11:44 AM | 7,748 Views
This is a very through review that was done on MRF. It compares the TMotor Props, the DJI original folding props, and the new 1552 folding props.

Posted by Tahoe Ed | Mar 12, 2014 @ 04:33 PM | 7,733 Views
After many questions on how to determine COG I have added this to my blog to make it easily accessible.

Setting up the Wookong M center of gravity (3 min 11 sec)