There have been several posts in the past where the Nine Eagles TX shown in the picture below showed 3 bars and would no longer work.
Finally a solution for this problem thanks to our Italian member marconos. He posted the solution but it was lost somewhat in the translation. He then posted a video and a fellow member shin (Hank) tried it to confirm the method.
These are Hank's words:
I pushed in and held the right stick heard the beep pushed down on the left stick and while holding both down moved both sticks in a few clockwise rotations and the tx went back to a normal display and works just fine.
Thanks marconos and Hank
Here is how site sponsor jasonjetski corrected the same problem:
Hi Durk,
First I removed the screws from the antenna mount to put my TX into Mode 2 as in the video. I don't know if I needed to do it,but I did.
While pushing the sticks both in,I turned the TX on and then move both TX sticks in a full circular motion a few times.
I noticed the "---" three lines were then scrolling up and down.
I then stopped moving the sticks and the screen came back to life again.
This is a very valuable lesson which Iam very grateful for the solution.It is sure to help others at a later time.
Regards Jason
And here is a new translation from marconos who first posted the solution to the problem:
step 1 - the radio is locked
step 2 - turn on the radio
Step 3 - press and hold simultaneously two stik crushed. (will display)
If the maneuver is done in mode 2 - the dashboard will appear soon
If the maneuver is done in mode 1 - 3 will see the lines moving (binding)
just turn off and on the radio.
And the video link to his video:
http://www.youtube.com/user/ZioWhite.../0/dK-ivU7BmzM
The video is dark and is here for reference.
Here is another post on this procedure:
https://www.rcgroups.com/forums/show...&postcount=780