Archive for February, 2008
Comments (0)
Add Comment
-
Views: 317
Two of the tears on the right wing of the Zero. The ruler is just covering my private info on my AMA sticker. -
Views: 280
Broken locator tab. The broken pieces were in the fuselage and will be reattached with epoxy. -
Views: 264
Here's the cowl and snapped-off stab. The stab's now back on the plane as of this writing. -
Views: 256
A bit of epoxy, a bit of paint and a bit of sanding and this cowl will be as good as new. The crazing is the extent of the damage. -
Views: 240
Here's where the stabilzer made its clean break from the tail section. The joiner wire poked a small hole through the top of the elevator half. I used the hole later on to CA the joiner back in place. -
Views: 259
The cowl and surrounding wood after reattachment. That hole in the wood, caused by a cowl attaching screw, has been filled with new balsa. -
Views: 246
Another view of the reattached firewall surround. -
Views: 262
Like a jigsaw puzzle whose pieces don't quite fit back in the same way, so too did the little bits and pieces of the servo tray fit back in their original positions. Sort of.