This drawing of the elevator pulley shows the two holes in the flange that I thread the cable out and back in. A drop of glue locks the cable in place.

AMT-disk.jpg - 30.0 KB - Views: 158
Posted by: dawsonh on Sep 01, 2011 03:06 PM
This drawing of the elevator pulley shows the two holes in the flange that I thread the cable out and back in. A drop of glue locks the cable in place.
 
AMT-disk.jpg
*
 elevator-disk-detailo.jpg
The elevator pulley.
>
 		elevator-disk.jpg
90° throw on my first pulley setup. This was later "improved" to 100° of throw (each way) when I enlarged the servo pulley a bit.
>>

« Previous 5 Attachments | Next 5 Attachments »

Castle Creations      DRIVE / FLY / SUPPORT