Snap the housing open and take out the board. You will have to unscrew two screws that hold the lens to the image sensor. once off the board put the lens back over the sensor and put two dabs of glue on the ends of the screws over the sensor.

IMG_1672.jpg - 42.1 KB - Views: 240
Posted by: blade thrasher on Nov 29, 2007 03:06 PM
Snap the housing open and take out the board.  You will have to unscrew two screws that hold the lens to the image sensor.  once off the board put the lens back over the sensor and put two dabs of glue on the ends of the screws over the sensor.
 
IMG_1672.jpg
*
IMG_1676.jpg
Cut 6mm piece of depron to fit as a backing.
>
IMG_1674.jpg
2 AAA = 22.7 g where 2 AA = 45.9 G. or any light combo of 3v.
>>

« Previous 5 Attachments | Next 5 Attachments »