Base for interior mold is made and smoothed. Be careful not to make a negative bevel. I almost did here. When the soft plastic is drawn down over the mold during vacuum forming, it will lock the mold in and be kind of hard to remove.

Canopy+5.jpg - 53.0 KB - Views: 80
Posted by: 6Sally5 on Apr 22, 2012 06:36 PM
Base for interior mold is made and smoothed. Be careful not to make a negative bevel. I almost did here. When the soft plastic is drawn down over the mold during vacuum forming, it will lock the mold in and be kind of hard to remove.
 
Canopy+5.jpg
*
 Canopy+6.jpg
Here is the completed mold ready for vacuum forming.
>

« Previous 5 Attachments | Next 5 Attachments »

Castle Creations      DRIVE / FLY / SUPPORT