The 2-piece landing gear held in place with four bolts (& thread-locker) I threaded into pre-installed blind nuts. Three access holes were pre-cut, so installation was a breeze.

wheel_pant_untrimmed_edited.jpg - 220.5 KB - Views: 392
Posted by: tailskid2 on Jul 19, 2006 05:47 AM
The 2-piece landing gear held in place with four bolts (& thread-locker) I threaded into pre-installed blind nuts. Three access holes were pre-cut, so installation was a breeze.
 
cockpit_bipe_edited.jpg
Sort-of bare wouldn't you say?
<<
cockpit_a_edited.jpg
Nice improvement - yes???? Notice how a pilot bust can be added and they blended to 'almost 3D!'
<
wheel_pant_untrimmed_edited.jpg
*
wheel_pant_edited.jpg
Wheel pants sure add a lot to the looks of an aircraft, & were easily installed!
>
covering_1_edited.jpg
I chose to extend the covering to fuel-proof the wing/fuse joint, protecting against the anticipated exhaust. (UltraCote Yellow #885)
>>