Final backing was made of thin foam-board.

engine_template_4_edited.jpg - 315.4 KB - Views: 422
Posted by: tailskid2 on Jul 19, 2006 05:47 AM
Final backing was made of thin foam-board.
 
cockpit_4_edited.jpg
What was needed for that big opening up front were some radial cylinders!
<<
engine_template_s_edited.jpg
A template was made to fit inside the cowl.
<
engine_template_4_edited.jpg
*
cowl_finished_c_edited.jpg
Not too shabby looking is it?
>
cowl_finished_e_edited.jpg
By removing one cylinder, engine cooling was accomplished. Engine cooling opening was smaller than the exit hole.
>>