R/C Groups RCCars Crack Roll Flying Giants RC Power The E Zone Lift Zone Our Sponsors
R/C Groups  


Go Back   RC Groups > Article Archive > RCPowermag Archive > Horizon Hobby's Hangar 9 Showtime 3D ARF Review > Horizon Hobby's Hangar 9 Showtime 4D ARF Review
Reload this Page Attachment 10.jpg (showing 12 of total 47)
Register Blogs Classifieds Clubs Members Regions Mark Forums Read

In no time the tail was complete.

10.jpg - 43.8 KB - Views: 358
Posted by: Steve H. on Jul 19, 2006 06:47 AM
In no time the tail was complete.
 
8.jpg
I double-checked the wing-to-fuse -- and found perfect alignment.
<<
 		9.jpg
This hole is pre-drilled in the joiner tube where the retaining bolt goes.
<
 		10.jpg
*
 19.jpg
Elevator servos installed.
>
 		11.jpg
The axles were threaded into the main gear after drilling the holes out slightly. When they paint them, the holes can get filled in a tiny bit so it doesnt't take much to clean them out.
>>

« Previous 5 Attachments | Next 5 Attachments »

Member Map - Contact Us - FAQ - Upgraded Membership - Arcade - Archive - Top

All RCGroups content copyright 1996 - 2009 by RCGroups.com and Jim Bourke except where otherwise indicated.
Terry the transmitter, the RCGroups name and logo, The E Zone, Lift Zone, and RC Power are all trademarks of RCGroups and Jim Bourke. Please report any misuse of our trademarks using the contact form. Thank you.

Powered by vBulletin, Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.