R/C Groups RCCars Crack Roll Flying Giants RC Power The E Zone Lift Zone Our Sponsors
R/C Groups  


Go Back   RC Groups > Article Archive > RCPowermag Archive > Horizon Hobby's Hangar 9 Showtime 3D ARF Review > Horizon Hobby's Hangar 9 Showtime 4D ARF Review
Reload this Page Attachment 4.jpg (showing 5 of total 47)
Register Blogs Classifieds Clubs Members Regions Mark Forums Read

Control horn installed -- I chose to add a locknut. (See text.)

4.jpg - 23.6 KB - Views: 260
Posted by: Steve H. on Jul 19, 2006 06:47 AM
Control horn installed -- I chose to add a locknut. (See text.)
 
2.jpg
The manual recommended drilling a hole in teh middle of each hinge slot to aid CA wicking. Nice touch! I also chose to seal my hinge gaps for even more security.
<<
 		3.jpg
This is one very lightly built wing!
<
 		4.jpg
*
 5.jpg
The instruction doesn't mention it, but it's a good idea to Locktite the plastic horn screws to help keep them secured.
>
 		6.jpg
I used Hangar 9 Aluminum servo arms, with the ball links to the bottom.
>>

« Previous 5 Attachments | Next 5 Attachments »

Member Map - Contact Us - FAQ - Upgraded Membership - Arcade - Archive - Top

All RCGroups content copyright 1996 - 2009 by RCGroups.com and Jim Bourke except where otherwise indicated.
Terry the transmitter, the RCGroups name and logo, The E Zone, Lift Zone, and RC Power are all trademarks of RCGroups and Jim Bourke. Please report any misuse of our trademarks using the contact form. Thank you.

Powered by vBulletin, Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.