|
RCCars | |
Crack Roll | |
Flying Giants | |
RC Power | |
The E Zone | |
Lift Zone | |
Our Sponsors | |
|
|
|||||||||||||||
|
||||||||
|
The locating dowels/antirotation pins installed in the wing.
<<
|
Wing cutout...On each cutout, I left a 1/4" of covering and then folded it insidea nd ironed it down to ensure a tight seal.
<
|
*
|
After marking the stab's position on the fuselage, I "cut" the covering with soldering iron. This way there's no chance of an Xacto cutting into the wood and weakening the stab. (The stab's fit into the fuse was very tight -- great!)
>
|
Tail installed. I sealed the gaps on every surface using clear Ultracote.
>>
|
