Attachment browser: 12.jpg

RCCars

Crack Roll

Flying Giants

		RC Groups > Article Archive > Ezonemag Archive > Extreme Flight Yak 54 68inch ARF Electrified Conversion Review! > Extreme Flight Yak 54 68inch ARF Electrified Conversion Review!
Attachment 12.jpg (showing 6 of total 53)

CA hinges were used on everything; and properly installed, I have never had one fail. Some of the pre-cut slots were covered with covering but it was not a problem to find them as the manual gave exact measurements to where they were located! After cuttin

12.jpg - 11.0 KB - Views: 111
Posted by: Steve H. on Jul 19, 2006 06:47 AM

The kit came with two sets of Dubro quality hardware! The manual mentioned the metric was included by mistake and to discard. I decided to keep it instead and store it in my spares box!

The labeled packages were a real plus. I've never seen an ARF do that before, it was most appreciated!

Servo openings cut open. There was not a pulling string in place, but none was needed due to large lightning holes.

Hinges installed, using pins to ensure they remain centered while curing.

« Previous 5 Attachments | Next 5 Attachments »